finer mesh

For questions about setting up the basic hydrodynamics. Bathymetry inclusion, tidal boundary conditions, river inclusion and so on..

Moderator: Saheedpp

Post Reply
sgharbi
Posts: 5
Joined: Thu Sep 24, 2015 6:11 pm
Full name: S. H. Gharbi

finer mesh

Post by sgharbi »

I am Sameer Gharbi , a Ph.D. student at Faculty of Marine Sciences-King Abdulaziz University.
I am running the COHERENS simulation in The Red Sea .I'm facing some problem regarding the creation of fine mesh in Bab-el-Mandeb strait (as shown in the attached file 'study area' ) region. If I am creating a finer mesh at the southern part, how can I link that with the coarser resolution at the northern part? I need to know how can I link different mesh grades.

Kindly help me with some suggestions.
Many thanks for any reply.

Best regards,
Sameer.
Attachments
studyArea.pdf
(25.26 KiB) Downloaded 1215 times
Katrijn
Posts: 87
Joined: Fri Nov 29, 2013 3:04 pm
Full name: Katrijn Baetens

Re: finer mesh

Post by Katrijn »

Hi there,
Your question is about nesting, so try to read the chapter in the manual and look up the test cases that use nesting (such as the optos, nos test cases).

Hope this helps you get started,

KAtrijn
sgharbi
Posts: 5
Joined: Thu Sep 24, 2015 6:11 pm
Full name: S. H. Gharbi

Re: finer mesh

Post by sgharbi »

Thank you sir for the reply, I read the manual and I'm going to run the test case .
Regards,
Sameer
Post Reply