Page 1 of 1

finer mesh

Posted: Mon Jun 13, 2016 11:31 pm
by sgharbi
I am Sameer Gharbi , a Ph.D. student at Faculty of Marine Sciences-King Abdulaziz University.
I am running the COHERENS simulation in The Red Sea .I'm facing some problem regarding the creation of fine mesh in Bab-el-Mandeb strait (as shown in the attached file 'study area' ) region. If I am creating a finer mesh at the southern part, how can I link that with the coarser resolution at the northern part? I need to know how can I link different mesh grades.

Kindly help me with some suggestions.
Many thanks for any reply.

Best regards,
Sameer.

Re: finer mesh

Posted: Wed Dec 07, 2016 10:15 am
by Katrijn
Hi there,
Your question is about nesting, so try to read the chapter in the manual and look up the test cases that use nesting (such as the optos, nos test cases).

Hope this helps you get started,

KAtrijn

Re: finer mesh

Posted: Sun Jan 01, 2017 10:56 am
by sgharbi
Thank you sir for the reply, I read the manual and I'm going to run the test case .
Regards,
Sameer